Use the Hydroforming Pressure Calculator to estimate the forming pressure required for tube or sheet hydroforming. Enter material properties, thickness, and relevant part geometry to review a preliminary pressure estimate in common units. The results can support early process planning, but actual pressure requirements should be verified for the material, tooling, and hydroforming method.

Inputs

Material
Yield strength (σy) is the stress at which the material starts to deform permanently (usually the 0.2% offset value, Rp0.2). Use the value for the actual grade and condition (annealed, cold-worked, heat-treated). Hydroforming works above yield, so strain hardening raises the real pressure. Account for it with the process factor or by entering a flow stress here.
МПа
мм
Tube Geometry
мм
ratio
Final expanded outer diameter divided by initial outer diameter (1.25 = 25% expansion). Must be ≥ 1.
мм
If entered, the calibration pressure needed to form this radius is also checked. Small radii often set the peak pressure.
Factors
Process factor (kп) is a user-supplied multiplier that covers what the basic model leaves out: friction at the die wall, lubrication, strain hardening, and how the tube is fed or the sheet is held. Blank = 1.00 (no adjustment). Use it only for preliminary comparison. The value must come from validated process data, such as your own trials, simulation or supplier data. Do not guess it.
×
Must come from validated process data. Leave blank if you have none.
×
Default: 1.25. Can be changed. Applied to the estimate as a multiplier.