Use the Tube Bending Springback Calculator to estimate the angle change that may occur after a tube is released from bending pressure. Enter the tube dimensions, material properties, bend radius, and bending angles to review a preliminary springback estimate and plan bend compensation. Actual results vary with the material, tooling, and bending process.

Inputs

Bending method

Unit system
مادة
Values are typical room-temperature figures. Replace them with mill certificate or tensile test data where available.
المعدل التراكمي
ميجا باسكال
ميجا باسكال
Hollomon hardening σ = K·εⁿ. Leave K and n blank to assume no work hardening.
–
Typical range is 0.05 to 0.55. Enter both K and n, or neither.
Tube geometry
مم
مم
مم
Angles & calibration
°
°
مم
The centerline radius the tube is held at under the rolls, before release. If you enter it, the tool predicts the finished radius for that setting.
×
Multiplies the theoretical springback. Work it out from testing or past production on the same material lot, machine and tooling: Ccal = measured springback ÷ springback predicted with Ccal = 1. Leave it at 1.00 if you have no validated data.