Use the Tube Bending Force Calculator to estimate the force required for a tube bending operation. Enter the tube diameter, wall thickness, bend radius, material yield strength, and bending method to review a preliminary force estimate in common units. Actual requirements vary with tooling, machine design, and process conditions.

Inputs

Bending method

Unit system

Switching units converts the values already entered.

Tube & material
مم
مم
Radius of the bend measured to the tube centerline (CLR), not to the inside or outside of the bend. In rotary draw it equals the bend die’s centerline radius. Often expressed as a multiple of D (e.g. 2D = 2 × OD).
مم
The material’s yield strength (0.2% offset proof stress) in its actual supplied condition. Use the mill certificate value where possible. Typical minimums are only approximate: e.g. ~205 MPa (30 ksi) for annealed 304 stainless, ~250 MPa (36 ksi) for mild steel. Annealed, cold-drawn and heat-treated tempers differ widely.
ميجا باسكال
Angle the tube is turned through, in degrees (a 90° elbow = 90°). Rotary draw: up to 180°. Ram/punch: below 180°; the model uses it to tilt the support reactions. Three-roll: up to 360°; steady-state roll force does not depend on angle in this model.
deg
Tooling geometry
Center-to-center distance between the two wing dies / support pivots on either side of the ram die.
مم
Center-to-center distance between the two outer (bottom) rolls of a symmetric pyramid three-roll bender.
مم
Diameter of the outer rolls measured at the bottom of the groove, where the roll contacts the tube.
مم
Factors
Optional multiplier on the theoretical force, for effects the model leaves out: strain hardening, friction, mandrel and wiper die drag, pressure die boost, lubrication. Leave at 1.00 unless you have a value from validated machine data, trials or engineering experience.
×
Design margin applied after the forming force is calculated: Design Force = Forming Force × SF. Choose it from your own design standard or company practice.
×