Use the Deep Drawing Pass Calculator to estimate how many drawing stages may be needed to form a cylindrical part from sheet metal. Enter the blank diameter, final cup diameter, and maximum drawing ratio per pass to get a preliminary pass estimate and indicative stage-by-stage diameter progression. Actual requirements depend on material properties, tooling, lubrication, and forming conditions.

Inputs

Length unit
Values you have entered are converted when you switch units (1 in = 25.4 mm).
The diameter of the flat, circular sheet-metal blank before the first draw. It is usually developed from the cup’s surface area plus trim allowance.
mm
The target cup diameter after the last draw, taken as the final punch diameter. It must be smaller than the blank diameter.
mm
The largest ratio allowed in one pass between the diameter going in (blank or previous stage) and the next punch diameter. For example, 2.0 means one pass can at most halve the diameter. It must be greater than 1.0.
ratio
Dimensionless. Enter the limit from your material data or design standard.
Optional material and process notes
For your records only. These notes are not used in the calculation.