Use the Plate Rolling Minimum Diameter Calculator to estimate the smallest inside diameter achievable when rolling a metal plate. Enter the plate thickness, material properties, and available machine capacity to review an estimated minimum diameter and radius. The result supports preliminary process planning; actual rolling capability depends on the machine configuration, material, and pre-bending conditions.

Inputs

Mode & Units
Plate & Material
Width measured along the roll axis.
Geometry Factor
Required. Basis: Dmin = 2 × K × t.
Machine Data (manufacturer)
The material yield strength on which the rated capacity is based (stated on the machine data sheet).
At least one of these two values is required for a machine-specific result.
Process Allowance
Must be based on machine data or validated shop experience — not a guess.